Preset Memories - Panasonic GP-VD150E Mode D'emploi

Hd communication camera
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 66

Preset memories

This unit enables up to 12 settings for the camera direction
(panning and tilting), zoom, focus, iris, gain and white
balance to be registered in its preset memories, and called.
w p The operating mode (manual or auto setting) is not
registered for the focus and iris settings.
The current focus and iris values are registered.
w p The focus and iris values can be recalled only when the
manual settings are applicable.
w p AWB A, AWB B or ATW is registered as the white
balance setting. The values selected when AWB was
established are recalled as the adjustment values of
AWB A or AWB B.
Notes
w p When there is a large difference in the environmental
temperature between the time of registration and the
time the setting is called, displacement of the preset
position may occur.
w p If displacement occurs, perform registration again.
w p While preset settings are being called, it is not
possible to perform manual operations such as
panning, tilting, zooming or iris adjustments.
w p If, when one set of preset settings has been called,
another set of preset settings is then called, the first
set of preset settings which have been called will take
precedence.
Twelve settings (preset No.1 to No.12) can be registered and
called using the wireless remote controller.
The [1] to [12] buttons correspond to the unit's preset
memories No.1 to No.12.
q Registering the settings in the preset memories
w
1
Display the picture to be shot on the monitor.
Operate the pan, tilt or zoom buttons to determine the
camera angle.
Adjust the focus, iris, gain and white balance if they
need to be adjusted.
2
While holding down the [PRESET] button,
press the button corresponding to the preset
memory number.
w p If a preset memory number with an already
registered setting has been selected, the existing
setting will be erased and replaced with the new one.
q Calling the settings of the preset memories
w
1
Press the button in which the preset memory
setting has been registered.
13 (E)

Publicité

Table des Matières
loading

Table des Matières