Features - Chamberlain LiftMaster PREMIUM Serie Mode D'emploi

Features

Your garage door opener is equipped with features to provide you with greater control over your garage
door operation.
Alert2Close
The Alert2Close feature provides a visual and an audible alert that an unattended door is closing.
Timer-to-Close (TTC)
The TTC feature automatically closes the door after a specified time period that can be adjusted using a
TTC enabled door control (Models 881LM or 880LM). Prior to and during the door closing the garage
door opener lights will flash and the garage door opener will beep.
®
MyQ
®
MyQ technology uses a 900MHz signal to provide two-way communication between the garage door
®
opener and MyQ enabled accessories. Your garage door opener is compatible with up to 16 MyQ
accessories.
SECURITY+ 2.0™ REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the factory to operate with your remote
control, which changes with each use, randomly accessing over 100 billion new codes. Compatible with
®
MyQ and Security+ 2.0™ accessories, see page 33.
NOTE: Older LiftMaster remote controls, door controls, and third party products are not compatible.
SECURITY+ 2.0™
Accessories
Up to 12
Remote Controls
Up to 2 Smart Control Panels or 4 of any other Security+ 2.0™ door
Door Controls
controls
Up to 1
Keyless Entries
®
THE PROTECTOR SYSTEM (SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing sensors will detect an obstruction in the path
of the infrared beam. If an obstruction breaks the infrared beam while the door is closing, the door will
stop and reverse to full open position, and the opener lights will flash 10 times. If the door is fully open,
and the safety reversing sensors are not installed, or are misaligned, the door will not close from a
remote control. However, you can close the door if you hold the button on the door control or keyless
entry until the door is fully closed. The safety reversing sensors do not affect the opening cycle.
MEMORY CAPACITY
ENERGY CONSERVATION
For energy efficiency the garage door opener will enter sleep mode when the door is fully closed. The
sleep mode shuts the garage door opener down until activated. The sleep mode is sequenced with the
garage door opener light bulb; as the light bulb turns off the sensor LEDs will turn off and whenever the
garage door opener lights turn on the sensor LEDs will light. The garage door opener will not go into the
sleep mode until the garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in; power is restored
after interruption, or when the garage door opener is activated. The lights will turn off automatically after
4-1/2 minutes. An incandescent A19 light bulb (100 watt maximum) or for maximum energy efficiency a
®
26W (100W equivalent) compact fluorescent light (CFL) bulb may be used.
Light Feature
The garage door opener is equipped with an added feature; the lights will turn on when someone enters
through the open garage door and the safety reversing sensor infrared beam is broken. For added
control over the light bulbs on your garage door opener, see page 27.
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted door control, remote control, wireless
®
keyless entry or MyQ accessory. When the door is closed and the garage door opener is activated the
door will open. If the door senses an obstruction or is interrupted while opening the door will stop. When
the door is in any position other than closed and the garage door opener is activated the door will close.
If the garage door opener senses an obstruction while closing, the door will reverse. If the obstruction
interrupts the sensor beam the garage door opener lights will blink 10 times. However, you can close the
door if you hold the button on the door control or keyless entry until the door is fully closed. The safety
reversing sensors do not affect the opening cycle. The safety reversing sensor must be connected and
aligned correctly before the garage door opener will move in the down direction.
25