Atlas Copco G2424-S200 Mode D'emploi page 9

G2424-S200
Legend to page 2
A Check free speed
Maximum 20500 r/min (rpm)
B Maximum air pressure: 6.3 bar ( 90 psig)
Operating instructions
Visual inspection
Tool and accessories
Inspect the tool and its parts visually before use.
■ Collet holder.
■ Throttle lever.
■ Lever catch.
Look for any damages or oil leakage that can compromise the safety of the tool.
Air installation
Inspect the air installation from the supply point to the tool visually before use.
■ Hose
■ Couplings
■ System pressure
■ Air filter
Look for any damage that can compromise the safety of the tool.
Precautions
Read the General Safety Instructions before using the die grinder.
WARNING Failure to follow correct working practices can result in serious injury or death
Ensure that the workpiece is properly supported
►
Maintain a balanced body position and firm footing
►
React quickly to excessive vibration due to damaged, or improperly mounted insert tool
►
Observe that stored compressed air in the hose may cause an accidental start
►
Release control device if the energy supply should fail
►
WARNING Electric shock
Should the product come in contact with electric circuits or other electrical power sources, there is a
risk of serious injury or death.
Never work near electric circuits or other electrical power sources
►
Make sure there are no hidden electric circuits in your working area
►
Personal protective equipment
The personal protective equipment must conform to the applicable health and safety regulations.
Always wear the following personal protection:
■ Safety helmet
■ Hearing protection
■ Safety goggles with side protection
■ Protective gloves
■ Safety footwear
EN
© Atlas Copco Industrial Technique AB - 9839 0487 00
Operation
9