Atlas Copco G2424-S200 Mode D'emploi page 10

Operation
Drugs, alcohol and medication
Drugs, alcohol and medication may impair your judgement and powers of concentration.
WARNING Poor reactions and incorrect assessments can lead to serious accidents or death
Never operate the product when you are under the influence of drugs, alcohol or medication
►
Prevent other people from using the product if they are under the influence of drugs, alcohol or
►
medication
Operation instructions
WARNING Air under pressure can cause serious injury
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply when not
►
in use, before making any adjustments to the machine, e.g. changing accessories, or when mak-
ing repairs
WARNING Wrong insert tool can burst and cause serious injury or death
Use insert tool with max operating speed higher or equal to the airgrinder speed
►
Do not use other insert tool than specified by the manufacturer (no cutting off wheels or router
►
bits).
■ Do not mix mm shanks with inch collets and vice versa
■ Observe a min of 10 mm (0.4") axial grip of the shank
■ When fitting mounted wheels or burrs, reduce the overhang by pushing the shank all the way into the
collet (Check also the recommendations given by the tool manufacturer)
■ Observe that increased overhang of shank reduces permissible speed
■ Before starting the machine, check that the collet is properly tightened
■ Test run every new mounted wheel in a safe position for 30 seconds. Be sure to use a barrier (such
as under a heavy work table) to stop any possible broken wheel parts. Stop immediately if vibration is
excessive
Legend to page 2
C Operation instructions
D Attach collet and shank
E Press safety catch forward and press trigger to start
F Air hose size: 13 mm (1/2 ")
G Maximum air pressure: 6.3 bar ( 90 psig)
10
EN
© Atlas Copco Industrial Technique AB - 9839 0487 00
G2424-S200