Publicité
Les langues disponibles
Les langues disponibles
I n s t a l l a t i o n
Personalised radio code
The personalised radio code is
registered using the two programming
keys "0" and "1". Do not use the
coding template.
The personalised radio code
!
"OOOOOOOOOO" is not valid
Indicator light response
Key presses required*
Press 0 and 1 simultaneously until
the red indicator light goes out
After the final simultaneous key press, the red indicator light will come on for 5 seconds to indicate the programming has
!
been successful.
If you make an invalid key press, if you wait more than 7 seconds between 2 key presses or if you do not press "0" and "1" simulta-
neously at the beginning or the end of programming, the red indicator light will flash to indicate an error. In all cases, wait until the flashing
GB
has stopped and carry out the registration procedure again.
34
Mark crosses on the 1st line of the grid below in the squares corresponding to
the personalised radio code on your base unit or telephone transmitter coding
template. (one cross for each hole)
1
0
Personalised radio code
Detector code
On the 2nd line write a "0" (zero) below each cross.
Fill in the empty squares on the 2nd line with "1" (one).
Carry out the registration procedure described below:
Registering the personalised radio code
1
0
For example, (do not use this) you have pierced holes 2, 7 and 8 on your template
Personalised radio code
Detector code
1
2
3
4
10 sequential key presses
corresponding to the radio code
to be programmed
1
2
3
4
X
1
0
1
1
5
6
7
8
9
10
1
Press 0 and 1 simultaneously until
the red indicator light goes out
5
6
7
8
9
10
X
X
1
1
0
0
1
1
0
!
Publicité
