Eliminating Blockages; Cleaning; After Every Use - Unitec MAB 825 Mode D'emploi

Eliminating blockages

Cleaning

After every use

MAB 825/845
WARNING
Danger of cutting by broken tool parts or shavings.
► Put protective gloves on before starting work.
Blockages caused by a broken tool:
Switch off the machine. Remove plug from the mains socket.
‹
Use the handle to move the machine slide to the upper posi-
‹
tion.
Replace defective tool. Remove shavings.
‹
Other blockages:
Switch the machine of at the motor switch. Leave magnetic
‹
clamp switched on.
Use the handle to move the machine slide to the upper posi-
‹
tion.
Remove shavings and check tool.
‹
WARNING
► Switch off the machine and pull the mains plug out of the
plug socket before starting maintenance and cleaning.
► When using compressed air for cleaning, wear protective
goggles and protective gloves and protect other persons in
the working area.
CAUTION
► Never immerse the machine in water or other liquids.
Remove the installed tool.
‹
Remove chips and coolant residues.
‹
Clean the tool and the tool mounting on the machine.
‹
Clean the guide of the machine slide.
‹
Return the machine and accessories to the transport case.
‹
Eliminating blockages
57