Operation; Activating/Deactivating Magnetic Clamp - Unitec MAB 825 Mode D'emploi

Operation

Activating/deactivating magnetic clamp

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
MAB 825/845
Activating magnetic clamp
CAUTION
► Switch on the magnetic clamp only when the machine is
standing on a magnetic substrate to avoid overheating of the
magnet.
Turn on switch (22). The indicator light in switch (22) comes
‹
on.
Check the magnet clamping force at the magnet indica-
‹
tor (24). When the magnet clamping force is sufficient, the
MAGNET POWER indicator light (24) is green. If the MAG-
NET POWER indicator light (24) is red, there is not sufficient
magnet clamping force available.
CAUTION
► The maximum magnet clamping force is only available after
switching on the motor.
Deactivating magnetic clamp
Secure the machine at the handle (10) to prevent the ma-
‹
chine from slipping off the surface.
Turn off switch (22). The indicator light in switch (22) goes
‹
out.
Operation
51