AEG F56302M0 Notice D'utilisation page 10

10 www.aeg.com
German de-
grees (°dH)
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
If you use multi-tablets containing salt
and the hardness of your water is lower
than 21°dH, you can set the lowest water
softener level. It deactivates the salt refill
indicator.
If you use standard detergent or multi-
tablets without salt, set the proper
water hardness level to keep the salt
refill indicator active.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
and the display is blank.
2. Press Program.
• The indicators
• The indicator
flash.
• The display shows the current
setting: e.g.
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
French degrees
(°fH)
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
,
and start to flash
and
go off.
continues to
= level 5.
mmol/l Clarke de-
grees
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
<0.7 < 5
6.3 The rinse aid empty
notification
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If you are using multi-
tabs containing rinse aid and you are
satisfied with the drying result, you can
deactivate the notification for refilling
rinse aid. However, we recommend that
you always use rinse aid for best drying
performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
and the display is blank.
2. Press Option.
• The indicators
go off.
Water softener lev-
el
8
7
6
1)
5
4
3
2
2)
1
,
and start to flash
and