Adjusting The Paper Near-End Sensor - Citizen CT-E601 Mode D'emploi

3.11 Adjusting the Paper Near-end Sensor

Change the settings of the paper near-end sensor to set the position at which the near-
end of the paper is detected.
1. Gently press the paper near-end sensor with your finger.
2. Keep the paper near-end sensor pressed as you move it left and right. The sensor po-
sitions are shown below for the various diameters of the paper roll used.
Sensor position
1*
2
3
4
Notes:
* Sensor position when shipped from the factory. However, factory settings differ depending on the destination
market.
Notes
The diameter of the roll of paper that is detected is an estimate. Some variations may occur de-
pending on the paper.
Paper roll outer diameter when near-
end is detected
Approximately ø22.0
Approximately ø25.0
Approximately ø29.0
Approximately ø34.0
Paper near-end sensor
Exterior/ interior diameter of core of
4
3
4
2
1 3
2
1
– 65 –
(Unit: mm)
paper roll used
ø18/ø12
ø18/ø12
ø18/ø12
ø18/ø12