Wired Controller Installation - Gree GMV-ND28T/A-T Manuel Du Propriétaire

4.4.2 Panel installation
(1) Detach the panel's Corner Cap, there is a mark "piping side" on one of the 4 corners, adjust
the panel direction so as to keep the mark and fittings on the same corner.
(2) Temporality hang the panel to body (there is four hangers on each corner of the panel, hang
the hangers to corresponding hooks on the body), as shown in fig 4.4.4.
(3) Detach the air inlet grille from panel, make a wiring connection of signal receiver. Notices that
the connection wire not stuck in the middle of body and panel, or may cause air leakage and
lead to condensation water drop.
(4) Tighten 4 screws at each corner of panel respectively, fix the panel on the body firmly.
(5) After tightening screws, reinstall the air inlet grille.

4.5 Wired controller installation

Wired controller is optional accessory. If wired controller is needed, please contact your local
dealer and install the wired controller according to the instruction manual.
Notes:
Do perform the commissioning operation before first use, automatic addressing or other settings,
please refer to the manual of ODU.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Multi Variable Air Conditioners Cassette Type Indoor Unit
indoor unit
ceiling
⑤
air outlet
13
sealing mater
5-8mm
decoration panel