Publicité
Les langues disponibles
Les langues disponibles
Mounting and installation
I
Information!
Always execute connection works in a deenergised status.
· If additional smoke switches (adhering to the DIBt (Deutsches Institut für
Bautechnik Berlin) for locking systems) or manual triggering button are to
be connected, then equip them with the included resistors according to the
connection diagram.
· Remove the plug-in connection bridge J2 (red) when utilising additional smoke
switches.
· Remove the plug-in connection bridge J1 (black) when utilising a manual trigge-
ring button.
I
Information!
A manual triggering button for locking systems with freely operating door closers
is imperative in accordance with the general building regulation approvals from
DIBt.
I
Information!
The complete system must be deenergised before every subsequent installation
of smoke switches or manual triggering buttons as well as before every alteration
or amendment to device configurations. All amendments or alterations will only
be initially acquired with a restart of the system.
Launching and testing
1
2
The green LED display will flash for approx. 4 seconds during the switching
The locking element/freely operating door closer is energised and the LED
3
The LED display switches for approximately 4 seconds from green to red when
The locking element/the freely operating door is deenergised and the door
The LED display illuminates as green when the time expires.
Remove the red protection cap.
Switch off the voltage supply.
procedure.
display illuminates as green.
Actuate the test button (light rod) to manually inspect the locking system.
the test button is actuated.
closes.
9
EN
Publicité
