Installation; Installation Of Light Curtain - Cedes cegard/Max C/CM Mode D'emploi

cegard/Max C/CM
5.

Installation

Due to the large optical aperture angle and the
automatic calibration feature, there is no alignment
needed as long as the edges are within the aperture
angle.

5.1. Installation of light curtain

For your own safety, switch main power off and mark clearly that the elevator or object is out of service.
Emitter (Tx)
2 0 °

E
E
R



E
O ther light sources
4
M 4 x 25
Receiver (Rx)
2 0 °
± 10°

R
R

> 100'000 lux
R E
O ther light sources
Installation and operation manual
 Ensure that the edges are mounted and operating
static and do not move during operation.
 Ensure both cables, emitter and receiver, exit in the
same direction
 Do not bend the cables or expose them to tension
 Ensure cables are kept as far as possible away
from AC mains or high voltages
 Do not force, stretch or squeeze the cables
 Ensure that the cable is well fastened and routed
 Avoid soiling of opto edges
 Avoid obstruction from door wings, cables etc. in

the protective area
 The emitter and receiver elements should face
each other.

 Do not bend or twist the edges!
 Oil can damage the cable. Contamination must
therefore be avoided at all times!

 Avoid external light from other infrared light sources
like photo eyes or light barriers!

 Avoid interference from other infrared sources such
E
as single opto elements, low energy bulbs, direct
sun light etc.
R

www.cedes.com
© CEDES/May 2012