Publicité
Les langues disponibles
Les langues disponibles
Bubbler Hose
Pump/Filter Outlet
Pump/Filter Inlet
Massage Jet Outlet
Massage Jet Outlet
Drain Valve
Floor Valve
Bubbler Floor
Fig 2
ASSEMBLY AND INSTALLATION:
SITE PREPARATION
1. Your spa should always be installed on a structurally sound, relatively smooth and
level surface.
2. Your spa should be connected to a grounded out
let within eight feet of the spa.
3. Make sure that there are no sharp objects under the spa.
INDOOR INSTALLATION:
Take special consideration to the following issues when installing your spa indoors.
1. Make sure the floor can support the total spa filled weight of 1500lbs.
2. Install your spa on a water resistant, non-slip floor. The floor should have a drain to
remove water splashed from the spa. Do not install the spa on carpet or other material
that will be damaged by moisture.
3. Allow enough clearance around the spa for full access to the spa equipment for
service.
4. Avoid installing the spa indoors on a second story above finished living space due to
the possibility of water and humidity damage.
5. Take into consideration the room humidity which will exist due to high temperatures.
Providing ventilation in the room will help maintain comfort and minimize moisture
damage to the surrounding environment.
OUTDOOR INSTALLATION:
You may install your spa on any smooth, level surface that is strong enough to support
the filled unit. The following considerations must be taken when installing your spa
outdoors.
1. Check local code requirements for restrictions such as fencing, enclosures,
childproof gates, etc.
2. Verify that there is adequate room to place the spa and permit safe access.
3. Do not install the spa on grass or dirt, as this will greatly increase the amount of
debris entering the spa. An 8'x8' stone or solid wood surface, 5 to 9 inches in height is
recommended.
4. Take into consideration the positioning of the Spa for draining purposes.
6
Publicité
