Publicité
Les langues disponibles
Les langues disponibles
DRAINING THE SPA:
NOTE: SURFACE MUST HAVE A FLOOR
DRAIN OR SUITABLE OUTLET FOR
DRAINED WATER BEFORE DRAINING.
1. Turn off the Filter/Pump, and unplug the
GFCI plug from the outlet.
2. Close the water inlet/outlet valve located
on the inside wall of spa by turning both
valves clockwise (Fig A)
Fig A
3. Detach hoses from the fittings on the
back of the Filter/Pump from the
corresponding fitting on the spa.
4. Locate the drain and make sure that the
inner valve is closed by turning it clockwise
until finger tight. (Fig 20a)
5. Slowly open and remove the drain plug
by turning it in a counter-clockwise
direction. (Fig 20b)
NOTE: IF WATER STARTS TO LEAK, THE
INNER VALVE IS OPEN AND NEEDS TO
BE SHUT BEFORE CONTINUING.
6. Attach a standard garden hose in place
of the drain plug. Make sure that the hose
is long enough to reach a suitable outlet
before draining (Fig 20c).
7. Open the inner valve by turning it
counter-clockwise (Fig 20d). This will start
the flow of water.
8.Allow spa to drain. Once all water has
been removed, tip spa onto the side of the
drain to empty out all remaining water.
9. Once drained, lay spa out to dry. Store
in a cool, dry location.
Drain
Fig 19
Fig 20a
Fig 20b
Fig 20c
Fig 20d
11
Publicité
