Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - NEFF N14D30N2 Notice D'utilisation

Getting to know your appliance

An overview of the models with their dimensions is given on
page 2.

The control panel

Displays
Heat settings
-
‚ Š
Residual heat
• / œ
Keep warm function
–
Timer
‰‰
Controls
Main switch
#
Control panel pause
"
( ) Hotplate selection
Adjustment fields
A @

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
When the hotplate is activated: the corresponding indicator lights up.

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
If appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the
#
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the #
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
Activating and deactivating
Use the ( ) symbol to select the hotplate. Touch the
symbol. A signal sounds. The
symbol until the display above the
Controls
Zone activation
ð
Keep warm function/childproof lock
–
Timer
3
Notes
When you touch a symbol, the respective function is
■
activated.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors. The
■
electronics could overheat.
ð
chocolate. As the hotplate cools down further, the display
changes to . The display remains lit until the hotplate has
œ
cooled sufficiently.
Notes
The hob switches off automatically if all hotplates have been
■
switched off for more than 15 seconds.
The settings remain stored for 4 seconds after the hob has
■
been switched off. If you switch it on again during this time,
the hob will operate using the previously stored settings.
activation symbol
13