Getting to know your appliance
An overview of the models with their dimensions is given on
page 2.
The control panel
/ NHHS ZDUP IXQFWLRQ
/ FKLOGSURRI ORFN
Controls
When you touch a symbol, the respective function is activated.
The hotplates
Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Tri-circuit hotplate
ò
When the hotplate is activated: the corresponding display lights up.
â
Hotplates with bridge heating element
Two individual hotplates can be interconnected with a bridge
heating element to create one large extended cooking zone
Under normal operation, these hotplates both work as normal
single-circuit and dual-circuit hotplates.
To activate the bridge heating element: the single-circuit
hotplate must be switched off.
Switch on the dual-circuit hotplate.
1.
Touch the
ë
symbol. The outer filament circuit on the dual-
2.
circuit hotplate is activated. The indicator light comes on.
Touch the
symbol again. The extended cooking zone is
ë
3.
activated. The indicator light comes on.
To deactivate the extended cooking zone: touch the
again. The indicator light goes out. The extended cooking zone
is deactivated.
You can also change the heat setting using the control panels
for the two hotplates.
&RQWUROV IRU
PDLQ VZLWFK
IRU DGMXVWLQJ WKH KHDW VHWWLQJ
ZLSH SURWHFWLRQ
&RQWURO IRU
s DFWLYDWLRQ
Activating and deactivating
Select the hotplate using the twist knob, touch the
Select the hotplate using the twist knob, touch the
activated.
Touch the
ë
'LVSOD\V IRU
³É KHDW VHWWLQJ
¤ UHVLGXDO KHDW
¯ RSHUDWLQJ UHDGLQHVV
7ZLVW SDG ZLWK WZLVW NQRE
IRU VHOHFWLQJ WKH KRWSODWH
Notes
The settings will remain unchanged if you touch several
■
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
symbol again, 3rd filament circuit is activated.
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
If
appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
cooled sufficiently.
symbol
ë
&RQWURO IRU
WLPHU IXQFWLRQ
symbol.
ë
ë
symbol, the 2nd filament circuit is
. The display remains lit until the hotplate has
œ
23