Getting To Know Your Appliance; The Control Panel; The Hotplates - NEFF T19 T06 Série Mode D'emploi

*Getting to know your
appliance
The instruction manual is the same for various different
y o u r a p p l i a n c e G e t t i n g t o k n o w
hobs. You can find the hob dimensions in the overview
of models. ~ Page 2

The control panel

Display
Heat settings
‚ - Š
Operating readiness
‹
Residual heat
• / œ
PowerBoost function
˜
Keep warm function
–
Timer
‰‰
Controls
Main switch
#
Keep warm function
–
PowerBoost function
˜
Automatic zone control
ð
Stopwatch function
œ
Timer
x
Kitchen timer / Childproof lock
U
Notes
When you touch a symbol, the respective function is
■
activated.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors.
■
The electronics could overheat.

Getting to know your appliance

The hotplates

Hotplate
Single-circuit hot-
$
plate
Dual-circuit hotplate Select the hotplate and touch the
ð
Tri-circuit hotplate
ò
When the hotplate is activated: the corresponding indicator lights up
Notes
Any dark areas in the glow pattern of the hotplate
■
are due to technical reasons. The function of the
hotplate is not affected.
Hotplate temperature is regulated by the heat
■
switching on and off. The heat may also switch on
and off at the highest setting.
With multi-circuit hotplates the heater elements of the
■
inner filament circuits and the heater element of the
activations may switch on and off at different times.
â Hotplates with bridge heating element
Two individual hotplates can be interconnected with a
bridge heating element to create one large extended
cooking zone.
Under normal operation these hotplates both work as
normal single-circuit and dual-circuit hotplates.
Activating and deactivating
symbol
Select the hotplate, touch the ð
the 2nd filament circuit is activated.
Touch the ð symbol again; the 3rd fila-
ment circuit is activated.
en
ð
symbol;
35