Greenlee G1 Versi-Tugger Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SPECIFIC SAFETY RULES AND SYMBOLS
This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
Failure to observe this warning will
result in severe injury or death.
Do not operate the cable puller in
a hazardous environment. Hazards
include flammable liquids and gases.
Failure to observe this warning will
result in severe injury or death.
Do not use this tool near live circuits. Shut off and
lock out power when working near existing circuits
Greenlee Tools, Inc.
SAFETY
ALERT
SYMBOL
Inspect and verify the maximum
load-bearing capacity or maximum
strength of all structural supports,
pulling system components and
anchoring systems before setting
up the puller. Any component that
cannot withstand the maximum cable
pulling forces could break
and strike nearby personnel with
sufficient force to cause severe injury
or death.
Do not allow anything other than the
pulling line to contact the capstan.
A grip, swivel, or other component
could break and strike nearby
personnel with great force.
Failure to observe this warning could
result in severe injury or death.
Do not stand directly under a vertical
pull. Cable could fall suddenly from the
conduit, injuring nearby personnel.
Failure to observe this warning could
result in severe injury or death.
Only use approved pulling lines and inspect pulling
lines before use. Never use pulling lines that are
under rated for the application. Approved pulling lines
include: mule tape, measuring tape, and pulling (poly)
line. DO NOT use strings, lines or rope that are not
intended for cable pulling such as general-purpose
rope. Failure to observe this warning could result in
severe injury or death.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
G1 Versi-Tugger™

Publicité

Table des Matières
loading

Table des Matières