Operation; Mounting Cordless Drill To Puller - Greenlee G1 Versi-Tugger Mode D'emploi

OPERATION

Mounting Cordless Drill to Puller

Use of the drill strap with the G1 is mandatory for safe operation. Failure to observe this warning could
result in injury.
1. Loosen the cordless drill chuck enough to accept
the input shaft.
2. Tighten the cordless drill chuck onto the input shaft.
Ensure the drill chuck is fully seated on the three
flats of the input shaft.
Input Shaft
Only use the G1 Versi-Tugger with approved pistol
grip style 12V-20V cordless drills. Do not use the G1
Versi-Tugger with corded drills, right angle cordless
drills, D-handle or spade handle cordless drills,
impact drills, or pistol grip style cordless drills whose
voltage is rated higher than 20V.
Greenlee Tools, Inc.
Cordless Drill
Drill Strap
End of Puller Frame
Drill Strap Buckle
12
3. Wrap the end of the hook and loop drill strap
around the hand grip of the cordless drill and the
end of the puller frame.
4. Insert the strap end through the buckle on the
opposite side of the frame as the drill. Pull the end
of the drill strap through the buckle.
5. Cinch the strap tight and fasten the hooks on the
strap end to the loops on the body of the strap.
6. Ensure that the strap is free of damage and dirt and
that the hooks are fully engaged with loops of the
drill strap.
Input Shaft
Drill Strap Buckle
End of Puller Frame
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
G1 Versi-Tugger™
Cordless Drill
Male
"hook & loop"
Hooks
Drill Strap Looped
Back Through Buckle