Replace The Scraper; Replace The Impeller - GreenWorks Pro 2601802 Manuel D'opérateur

EN
9.2

REPLACE THE SCRAPER

1. Put the machine on a flat, level surface.
2. Face up the impeller (7).
3. Remove the 4 screws below the impeller (7) that attach
the scraper (6) to machine.
4. Remove the worn scraper (6).
5. Install the new scraper (6).
6. Install and tighten the screws (13) that you removed.
9.3

REPLACE THE IMPELLER

1. Remove 6 screws on the right side cover.
2. Pull the belt tensioner away from the engine pulley. Make
sure that the washer, spring and screw are not missing.
3. Remove the belt.
13
6
6
English
4. Remove the 4 screws.
5. Remove the 6 screws on the left side cover.
6. Remove the nut on the left side plate.
7. Remove the impeller shaft with pulley assembly attached.
8. Remove the damaged impeller (13). Make sure that the
shaft sleeve on the left side of the shaft is not missing.
10