Eurochron ETH8000 Notice D'emploi page 2

OPERATING INSTRUCTIONS
Item no. 672591 / Version 12/11
SOLAR THERMOMETER/HYGROMETER ETH8000
INTENDED USE
The solar thermometer/hygrometer displays the temperature and the air humidity
at the installation location.
Power is supplied via the inbuilt solar cell, which charges the integrated battery.
Do not use any other power supply.
Any use other than described above is not permitted and can damage the product.
In addition, it can lead to dangers such as short-circuit, fi re and electrical shock.
Always observe the safety instructions and all other information included in these
operating instructions.
This product complies with the applicable National and European regulations. All
names of companies and products are the trademarks of the respective owner. All
rights reserved.
SAFETY INSTRUCTIONS
Please read all of the operating instructions before using the product
for the fi rst time; they contain important information about the correct
operation. The warranty will be void in the event of damage caused by
failure to observe these safety instructions! We do not assume any liabi-
lity for any consequential damage!
Nor do we assume any liability for material and personal damage caused
by improper use or non-compliance with the safety instructions! In such
cases, the warranty will be null and void.
- For safety reasons, any unauthorised conversion and/or modifi cation of the
product is not permitted. Never dismantle the product.
- The product is intended exclusively for use in dry interiors; it must not get damp
or wet.
- The manufacturer does not accept any liability for incorrect or inaccurate readings
or any consequences resulting from such readings.
- This product is not a toy and does not belong in the hands of children. Only use
the product out of the reach of children; the product contains small parts that
could be swallowed.
- Condensation may form when the product is brought from a cold room into a
warm one. Wait until it has reached room temperature before using it.
- Do not leave packaging materials lying around carelessly. They may become dan-
gerous playthings for children.
- Handle the product with care. It can be damaged by impact, blows, or by being
dropped, even from a low height.
DESCRIPTION OF THE FEATURES
- Simultaneous display of thermometer and hygrometer values
- Max-min value recorder for temperature and air humidity
- Comfort display using symbols
CHARGING THE INBUILT RECHARGEABLE BATTERY
- The inbuilt rechargeable battery is charged using the solar cell on the front of
the device.
- The solar cell can also charge the battery in artifi cial lighting, but the effi ciency
is not as high as with direct sunlight. The charging time shortens when charging
via sunlight, but direct radiation with sunlight can lead to incorrect measure-
ment data.
- When the battery is fully recharged it can be used for about one month without
solar energy.
- When the display contrast fades or the screen display disappears, place the
device in a brightly-lit place, so the battery can recharge.
SETUP/WALL MOUNTING
The thermometer/hygrometer can stand up or be hung on the wall.
Setup:
- Fold out the support on the back of the device and place the device on an even,
fl at and stable surface.
- Protect valuable furniture surfaces by using a suitable underlay; otherwise, it
may cause scratch marks.
Wall mounting:
- Fold in the support on the back of the device and hang the device up on a nail or
screw.
- There is an eyelet for hanging up on the back of the device.
OPERATION

The sensors for the thermometer and the hygrometer are located inside the
housing and thus display the values for the interior of the housing.
Therefore, to obtain more accurate measured values do not hold the device
in your hand or stand/hang it near a heat source, instead stand/hang it in an
open area.
The measurement display needs about 15 to 30 minutes to stabilise and
show accurate values.
- Use the ON/OFF switch below the mounting foot on the back to turn the device
on and off.
ON Device on
OFF Device off
- Press the MAX button to display the maximum values for the temperature and
air humidity.
- Press the MIN button to display the minimum values for the temperature and air
humidity.
- Press the corresponding button again or wait several seconds to return to the
current display.
- Press the RESET button to delete the stored max-min values and start recording
the max-min values again.
- Next to the humidity indicator in the lower display, a symbol appears that gives
information about the current comfort value:
Frost Warning (Temperature between +4 °C and -1 °C)
Humidity Too Low (Humidity <50%)
Humidity Too High (Humidity >70%)
Comfort Zone (Humidity between 50% and 70% and temperature between
+20 °C and +26 °C)

If the display does not show anything or shows it wrongly, press the RESET
button to reset and restart the device.
MAINTENANCE AND CLEANING
The product does not require any maintenance and should never be disassembled
for any reason.
Please use a soft, dry, clean cloth for cleaning. Do not use aggressive detergents as
these can cause discoloration of the case.
DISPOSAL
Electronic devices are recyclable waste materials and must not be disposed
of in the household waste!
Please dispose of the product, when it is no longer of use, according to the
current statutory requirements.
TECHNICAL DATA
Operating voltage: 1.2 V/DC (inbuilt rechargeable battery)
Battery life: approx. 1 month (with fully recharged battery)
Thermometer: -10 to +50 °C / resolution 0.1 °C
Hygrometer: 20 - 95 % rel. humidity (resolution 1 %)
Dimensions: 77 x 150 x 18 mm
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by
any method, e.g. photocopy, microfi lming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. These ope-
rating instructions represent the technical status at the time of printing. Changes in technology
and equipment reserved.
© Copyright 2011 by Conrad Electronic SE.