Troubleshooting - Garland 310 DPG Manuel D'instructions

English

9. TROUBLESHOOTING

Depending on the symptoms that you might observe, you can detect the probable cause and solve the problem:
If the machine does not start, check the engine compression and the spark from the spark plug.
Depending on the symptoms, we attach a table with probable causes and solutions:
Cylinder
Spark plug
compression
works
normal
Yes
Yes
Not enough
compression
Engine does not
turn
Probable cause
No petrol in deposit
Petrol filter is dirty
There is water in the petrol mix
Yes
Petrol used is not adequate
The carburetor is dirty
Switch is in the Off position
No
Spark plug is dirty
The connecting pipe to the spark
plug is not well connected
Spark plug is loose
Piston and segments are worn out
Yes
Cylinder deteriorated
Engine burnt out
38/128
Corrective action
Put petrol in deposit
Clean the filter
Replace the petrol
Change the petrol used
Take the machine to your
nearest official service agent
Place the switch on the On or
"I" position
Limpie la bujía
Connect the pipe correctly
Tighten
Take your machine to your
nearest official service agent
Take your machine to your
nearest official service agent.
Take your machine to your
nearest service agent