Operation In Detail - Klarstein MIDNIGHT SUN Mode D'emploi

OPERATION IN DETAIL

Commissioning
When you use the heater for the first time, you must first connect the remote control and
the socket receiver.
• First plug the socket receiver into the socket.
• Press and hold the ON/OFF button on the socket receiver for 3 seconds.
• Then press the two remote control buttons °C/°F and MODE simultaneously until
you hear a beep and both units are connected.
Note: The connection between the two devices should be completed within 3
minutes, otherwise you will need to press the button on the socket receiver again to
restart the connection process.
Operating the heater by remote control
Press the ON/OFF button on the remote control to switch the heater on and off.
When you turn the heater off, only the heater but not the remote control is turned off, it
continues to send signals to the power outlet receiver.
Note: The ON/OFF button on the receiver is for pairing mode. To turn the heater on
and off, use the ON/OFF button on the remote control.
Switching the child lock on/off
Press and hold the LOCK button for 3 seconds to turn the button lock on or off.
Selecting the display format
Press the °C/°F button to select the desired display format.
EN
25