Operation Of The Led Light Strip; Set Description And General Functions - Klarstein MIDNIGHT SUN Mode D'emploi

EN
22
3. Align the mounting holes with the dowels Insert the screws through the mounting
holes and tighten them. Finally, place the rubber plugs on the holes.

OPERATION OF THE LED LIGHT STRIP

Once the heater is installed and wired, the LED is controlled by the light switch on the
wall. When the LED is switched on, the standard light colour is cool white, when the LED
is switched off and on again, the light colour changes to warm white.
Note: The LED lighting can only be used as decoration.

SET DESCRIPTION AND GENERAL FUNCTIONS

Each set consists of two parts:
• A remote control with digital display, which houses the electronics, the controls and
the built-in room temperature sensor.
• A socket receiver that can receive and decode the signal from the remote control.
Remote control functions
The remote control uses its integrated sensor to detect the room temperature and
sends a signal to the socket receiver to switch the heater on and off when the ambient
temperature changes, thus maintaining a constant room temperature.
• If the room temperature is 0.5 °C higher than the target temperature, the remote
control sends an OFF command to the receiver. The heater is switched off.
• If the room temperature is 0.5 °C lower than the target temperature, the remote
control sends an ON command to the receiver. The heater is switched on.