Honeywell F50F Mode D'emploi page 12

Masquer les pouces Voir aussi pour F50F:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STEP 1
Put the cell(s) on the lower rack of the dish-
washer with the airflow arrow pointing up. It may
be necessary to remove the upper rack. Do not
block water flow to the upper arm.
HINT: Lay a few large water glasses between
STEP 2
Using your regular dishwashing detergent, allow
the dishwasher to run through the complete
wash and rinse cycle. Do not use the dry
cycle. To avoid burns, let the cell(s) cool
completely before removing, or wear protective
gloves when removing the cell(s). Remember
that water may be trapped inside the cell(s)
plates. Tip the cell(s) so these tubes can drain.
STEP 3
Wipe the ionizer wires and contact board on the
end of the cell using your thumb and forefinger
with a small, damp cloth.
STEP 4
Inspect the dishwasher. You may wish to rerun
the wash and/or rinse cycle with the dishwasher
empty if you see dirt or residue from washing
the cell(s). If dirt or residue seems excessive,
wash the cell(s) more often or try a different
detergent.
Washing
CAUTION
the
cell(s) in
Hazardous chemical.
a tub
Can cause personal injury.
NOTE: Always wash the cell(s) first, then the
69-0756B—2
the spikes on the lower rack, and rest the
cell(s) on them so the spikes do not damage
the aluminum collector blades.
• Do not splash the detergent solution in
eyes. Wear rubber gloves to avoid
prolonged detergent contact with your skin.
• Keep detergent and solution out of reach
of children.
prefilter(s), to keep heavy prefilter lint
from getting caught in the cell(s).
10

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

W8600f

Table des Matières