QSC GXD Guide De Mise En Route Rapide page 6

PRESET SAVE AS
Select the LOCATION and/or change the NAME to save changes you make to the DSP.
See Figure 17 and Figure 18
1. From HOME
ENTER
2. B PRESET,
3. B PRESET SAVE AS,
4. B LOCATION
5. B the LOCATION (P1 to P20),
6. B NAME,
7. B letter, number, hyphen, or space
8. B SAVE,
STEREO DSP or DSP A and DSP B
STEREO DSP is set for both channels equally, at the same time. Separate DSPs (DSP A and DSP B) are set independently for each channel. The
Sensitivity controls are linked in both Stereo DSP and dual mono DSP. Switching between Stereo DSP and Separate DSP is done by recalling presets
EN
that are either stereo or dual mono.
Any changes you make are made in real time – you hear the change as it is being made.
NOTE!: The term "STEREO DSP" is used in this document as a generic term to mean either STEREO DSP or DSP A/DSP B, unless
specifically noted.
SENSITIVITY
See Figure 19
1. From HOME
ENTER
2. B STEREO DSP,
3. B SENSITIVITY,
4. B 1.2 V (+4 dBu), 3.9 V (+14 dBu), or TouchMix™,
CROSSOVER and POLARITY
See Figure 20 through Figure 22.
1. From HOME
ENTER
2. B STEREO DSP,
3. B CROSSOVER,
4. B HPF,
5. B FREQUENCY (BYPASS, 20 Hz to 4 kHz),
6. B LPF,
7. B FREQUENCY (BYPASS, 60 Hz to 4 kHz),
8. B POL,
9. B positive (+) or negative (-),
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER HOME
repeat. When finished
EXIT
ENTER
CROSSOVER > HIGHPASS
0
-6
HPF POL
FREQUENCY: 60 Hz
— Figure 20 —
ENTER
ENTER
6
PRESET > SAVE AS
P20: MONO SUBS 100 HZ
LOCATION NAME
ENTER TO SELECT
— Figure 17 —
PRESET > SAVE AS
P20: MONO SUBS 100 HZ
ENTER: PRESS TO ADVANCE
HOLD TO ACCEPT
— Figure 18 —
DSP > SENSITIVITY
SENSITIVITY: 3.9V (+14dBu)
SENSITIVITY: 3.9V (+14dBu)
— Figure 19 —
CROSSOVER > LOWPASS
0
-6
LPF HPF POL
FREQUENCY: 2000 Hz
— Figure 21 —
CROSSOVER > POLARITY
+
HPF POL
POLARITY: +
— Figure 22 —
SAVE
LPF
LPF