Publicité
Les langues disponibles
Les langues disponibles
Pressure Washers
Pre-Operation
UNPACKING
Remove the equipment and all parts
from the carton. The carton should
contain the following.
•
One pressure washer (pump,
engine, cart base).
•
One cart handle assembly.
•
One spray gun.
•
One lance with nozzle.
•
Spray tips (not included with all
models).
•
One high pressure hose.
•
One pack of nuts, bolts, and
manuals.
•
One or two bottles of engine oil.
If any parts are missing, DO NOT
RETURN THE UNIT TO THE RETAILER.
Know the unit's model number (locat-
ed on the serial number tag on the
pressure washer frame) and call 1-800-
330-0712 for replacement parts.
After unpacking the product, inspect it
carefully for any damage that may
have occurred during transit. Make
sure to tighten fittings and bolts
before using the pressure washer.
Do not operate the
WARNING
!
unit if it's damaged
during shipping, handling, or use.
Damage could result in bursting and
cause injury or property damage.
ASSEMBLY
Use 1/2" wrench to assemble pressure
washer.
1. Slide the handle assembly over the
lower legs of the cart base. Use the
standard nut and bolt to secure the
legs. See Figure 1.
Figure 1 - Assemble Handle
2. Connect clear plastic detergent hose
to brass barb on pump (See Figure 2).
www.chpower.com
Figure 2 - Connect detergent hose to
brass barb
3. If applicable: insert quick connect
tips into rubber holders on front of
placard (See Figure 3).
Figure 3 - Insert quick connect tips
4. Secure garden hose (not included) to
the inlet connection on pump (See
Figure 4).
Figure 4 - Secure garden hose
5. Connect the high pressure hose to the
pump outlet (See Figure 5).
4
Figure 5 - Connect high pressure hose
to pump
6. Attach the lance with nozzle to the gun
(See Figure 6).
Figure 6 - Attach lance to gun
7. Install quick connect tip, if applicable
(See Figure 7).
Figure 7 - Quick Connect Tip
Publicité
