Numan Two Mode D'emploi page 87

Depending on your device, you may need to make multiple attempts at Pairing and/or Connecting to the NUMAN
Two, but please give your device adequate time to Pair or Connect before repeating the process.
Pairing A BT Wireless Technology Enabled iPhone /iPod touch/iPad:
1. Press source to select BT mode. This will power on the BT. Turn the volume up about ¼ to start. Also turn up
the volume on the source device (the device you are streaming from).
2. Select "Settings". (Depending on software version).
3. Select "General".
4. Select "BT".
5. Switch BT "On" to initiate searching.
6. Select "NUMAN Two" when it appears on the display.
7. You will hear a ring tone from the NUMAN Two and you can begin playing your music files wirelessly. Adjust
the volume level on your device. You should not have to pair your iPhone/iPod/iPad again. The volume output
level of music files varies.
If you prefer an even higher output level, check the settings in your iPhone/iPod touch/iPad: Set the EQ Off, the
SoundCheck Off, and the Volume limit Off. If you encounter a problem Pairing, press the small arrow to the right
of "NUMAN Two BT" on your iPhone /iPod touch/iPad display and select "Forget this Device", then repeat the
Pairing process.
Depending on your device you may need to make multiple attempts at Pairing and / or Connecting to the
NUMAN Two, but please give your device adequate time to Pair or Connect before repeating the process.
87