Numan Two Mode D'emploi page 83

NOW PLAYING INFORMATION
While an FM station is playing, the screen shows one of the two following sets data:
• If RDS information is available, by default the service name (i.e. station name) is displayed. You can cycle
through further RDS information by pressing INFO. Each time you press the button, another set of information
is displayed, cycling through RDS radio text, RDS programme type, frequency and today's date.
• If no RDS information is available, the currently tuned frequency is shown.
SCAN SETTINGS
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss) from
weak stations. To change the scan settings to stop only at stations with good signal strength, select:
MENU > Scan settings > Strong stations only? > YES.
AUDIO SETTINGS
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor signal-to-
noise ratio (hiss). To play weak stations in mono, select:
in mono only > YES.
MENU > Audio Settings > FM weak reception: Listen
83