Publicité
Les langues disponibles
Les langues disponibles
System connection e
System connection e
• • Never cut the insulation on the power wire or use it to power any other equipment. If the rated current
capacity of the power wire is exceeded, fire and electric shocks may result.
• • The wires should be secured with tape or a similar securing method to prevent any obstructions while
driving. If they get wound or entangled around components such as the steering wheel, shifting lever,
or brake pedal, accidents may result.
• • If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire
insulating method around the connection to insulate it. If the connection is not insulated, fire or
accidents may result.
Tip
• • Install and connect all of the peripheral equipment before connecting them to the main unit.
• • Do not remove any of the protective caps (RCA, etc.) unless in use.
• • Be sure to wrap the connection wires with tape (PVC tape) to insulate them.
• • Adjust the external amplifier's input level.
■
System for the CD5000
1) CD5000 Main unit, used alone
NO CONNECTION (Do not remove cap)
TO ACC (Power Supply)
TO BATTERY+12V (Permanent Supply)
TO POWER ANTENNA RELAY (Supply)
TO HEAD LIGHT SWITCH (Illumination (+) )
TO TURN-ON WIRE OF EXTERNAL EQUIPMENT (Supply)
2
NO CONNECTION
NO CONNECTION
Red
Yellow
Blue
Orange/White
Blue/White
Black
TO GROUND
INTERCONNECTING WIRES
(Power and speaker connector)
- 8 -
xample
xample
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
NO CONNECTION (Do not remove cap)
1
MAIN UNIT
ANTENNA PLUG
16P
White
White/Black
FRONT
Gray
SPEAKERS
Gray/Black
Green
Green/Black
REAR
Purple
SPEAKERS
Purple/Black
Brown
TO STEERING REMOTE CONTROL
Brown/Black
Publicité
