oventrop OKP 10 Instructions D'installation Et D'utilisation page 12

Illustr. 8: Roof hook "bottom"
(c)
(d)
4. Hang foot rail with plastic caps into the mounting rail.
For this purpose, the tightening sheet (a) has to be
pushed upwards.
Illustr. 10: Push tightening sheet (a) "upwards"
Illustr. 11: Position foot rail in the mounting rail
Illustr. 12: Position foot rail in the mounting rail
12
(a)
(b)
(a)
(b)
Illustr. 13: Push tightening sheet (a) "downwards".
Tighten both M8 screws firmly.
Please make sure that no humidity may penetrate
the vacuum tubes/collector housing. Do not install the
collector during humid conditions or in rain.
5. Hang collector housing into the mounting rail. For this
purpose, the tightening sheet (c) has to be pushed
upwards.
(c)
Illustr. 14: Push tightening sheet (c) "upwards"
Illustr. 15: Position collector housing in the mounting rail
(c)
Illustr. 16: Push tightening sheet (c) "downwards".
Tighten both M8 screws firmly.
(a)
(d)