Electromagnetic Compatibility En 60601-1-2; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Mectron MULTIPIEZO PRO Mode D'emploi Et Maintenance

11.1 Û ELECTROMAGNETIC COMPATIBILITY EN 60601-1-2
DANGER: Interference with other
equipment. Though compliant with the
standard IEC 60601-1-2, the multipiezo
pro may nonetheless interfere with other
devices nearby.
The multipiezo pro must not be used near
to or stacked on other devices. However,
if this were to prove necessary, you must
check and monitor correct operation of the
device in that configuration.
DANGER: Portable and mobile radio
communication appliances may affect the
correct functioning of the device.

Guidance and manufacturer's declaration - Electromagnetic emissions

The multipiezo pro is intended for use in the electromagnetic environment specified
below. The customer or user of the multipiezo pro should ensure that it is used in such an
environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
equipment. An electrical scalpel or other
electro-surgical units near the multipiezo
pro device may interfere with its correct
operation.
EMC precautions and must be installed
and activated in accordance with the EMC
information given in this paragraph.
Compliance Electromagnetic environment – Guidance
Group 1
The multipiezo pro only uses RF energy for
internal function. Therefore, its FR emissions
are very low and are not likely to cause any
interference with nearby electronic
equipment.
Class B The multipiezo pro is suitable for use in
all establishments, including domestic
establishments and those directly connected to
Class A
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Complies
11 Û TECHNICAL DATA
DANGER: Interference from other
DANGER: The device requires specific
EN
39