Use; Switching The Device On And Off; Turning The Device Off - Mectron MULTIPIEZO PRO Mode D'emploi Et Maintenance

MULTIPIEZO PRO
Correctly connect the handpiece on its
cord making sure to match the dot on the
handpiece connector with the groove on the
cord connector.
Make sure that the electrical contacts of
both handpiece and cord are perfectly dry; if
need be, dry them by blowing compressed
EN
air;
Position both handpieces on their supports.
Only one handpiece can be used at a time,
it is therefore necessary to put the unused
handpice back to its place in order to enable
the other one to work .
NOTE: the multipiezo pro will recognize that
the handpiece is on its own support also by
placing only the cord properly.
05 Û USE
05.1 Û SWITCHING THE DEVICE ON AND OFF
Turning the device on
With the device in view from its front side,
position the switch on the left of the device
body on position "I", being careful not to press
the foot pedal.
4 symbols appear on the device (ref. U inside
cover) that turn off one by one. At this point, the
device sets on the default setting and is ready
for it to be used.

Turning the device off

With the device in view from its front side,
position the switch on the left of the device
body on position "O", being careful not to press
the foot pedal.
The device turns off.
12
6
7
PLEASE NOTE whenever the device is
started, the following default setting is
programmed: "power" 1, "light" AUTO,
"function" ENDO, "irrigation" 1.