Clean Function; Û Clean Function - Mectron MULTIPIEZO PRO Mode D'emploi Et Maintenance

06 Û CLEAN FUNCTION
The CLEAN function allows to run a cleaning cycle on the irrigation circuit of the handpiece(s)
used during the treatment, by following the steps described in this chapter.
WARNING: Clean function. The
CLEAN function must be used after every
treatment, before starting the cleaning and
sterilization procedures.
handpiece
power light function
6 auto endo
5 5 on perio/scaler
4 4
off restorative
3
2 soft mode
1
0
function
endo
perio/scaler
restorative
soft mode
the crystallization of the salts may seriously
damage the device.
1
2
3
multipiezo pro
clean irrigation
6
auto
stop 5 5
4 4
3
2
1
0
4
06 Û CLEAN FUNCTION
WARNING: If the tubes are not cleaned,
Fill in the bottle with water, possibly
deminaralized water.
Connect the bottle to the device;
Position the handpeice, with or without
insert, above a container to contain the
liquid that will outflow during the cleaning
cycle;
To enter the cleaning mode, select "auto"
under the CLEAN menu on the touch
keyboard: all the other selection options
present on the display are disabled;
PLEASE NOTE You can exit the cleaning
mode at any time by pressing on "stop"
under the CLEAN menu, the keyboard is
enabled again, and displays the last setting
used.
To make the CLEAN function start while the
screen is flashing, press the foot pedal once
and release it: the screen stops flashing and
the cleaning cycle starts;
EN
21