Use - Qilive Q.5660 Mode D'emploi

4.3 Fitting and removing accessories
EN
• CAUTION: Before changing accessories, always switch the vacuum cleaner off first.
CAUTION: Risk of injury! Never hold the crevice nozzle close to the body or it may
•
stick to the skin. If the nozzle does get stuck, switch off the appliance immediately.
• All three accessories: crevice nozzle, small floor nozzle and round brush nozzle can
be connected both to the tube and directly to the main body.
4.4 Disassembling
1. To disconnect the tube from the main body, press the main body release button and
separate them.
2. To use one of the three accessories, first disconnect the floor nozzle or the tube by
pressing the its release button.
3. To disconnect any accessory, press its release button and pull it out.

5. USE

5.1 Charging the battery pack
Notes:
• Prior to first use, the lithium-ion battery must be fully charged, even if it comes with
a partial charge.
• Only charge the appliance using the power supply unit provided!
• The appliance cannot be used while charging.
• Before charging, switch off the appliance. The regular charging process takes
4-5 hours. To maintain the peak performance of the battery, it is recommended to
charge the battery for 4-5 hours once a month if the appliance is not used regularly.
1. Charging the battery in the handstick vacuum cleaner: Hang the appliance on
its wall mounting bracket. Plug the charger tip into the charging port on the top of
the battery pack.
2. Charging the battery out of the handstick vacuum cleaner: To remove the
battery, squeeze the battery release buttons and slide backwards. Plug the charger
into the charging port on the battery.
3. Plug the charger into a wall socket.
1
Note: The charging indicator flashes blue while charging. It turns green when fully
charged.
2
12