Handicare MiniLift160EE Manuel D'utilisation page 4

Assembly
Check to ensure that all components are included:
Lift unit, control box and battery pack, undercarriage, footplate, leg support, hand control and cord, user manual and
charger.
The lift is collapsed when delivered. Set up the lift, according to the following instructions
(no tools required):
1. Lock castor brakes. 1
2. Place the mast in the base
3. Mount the lockninghandles at the base of the mast.
4. Tighten locking handle (1).
5. Check all mounting fixtures and locking handles.
6. Deactivate the emergency stop function and perform a final inspection (see Final
inspection).
Connect cables: Hand control cord in HS, cable to lift unit on mast in outlet M1, and
cable to base-width motor in outlet M2. (EE)
HS
M1 M2
To collapse the lift, follow the instructions below.
1. Lock castor brakes.
2. Change the base width pedal to horizontal.
3. Remove legsupport and footplate.
4. Run the lift arm to the lowest position, and then activate in the emergency stop button.
5. Push the lift arm in as far as possible.
6. Loosen the locking handle at the base of the mast (1). You need not remove the locking handle.
7. Lift up on the mast and lower it towards the undercarriage.
Warning, risk of pinching (between base and mast)
8. Pull the mast back and tighten the locking handle (1).
U S E R M A N U A L SystemRoMedic
4
TM