Publicité
Les langues disponibles
Les langues disponibles
Connection of the drive voltage
A separate connection track is necessary to supply electricity to the rails. The power can be supplied th-
rough any track element (except in the case of points or decoupling tracks), by means of the installation of
a feeder element equipped with a connection cable. The feeder element is attached to the holder provided
for it with a screw (Figs. 3 and 4. The contact to the rail takes place across the contact pin on the circuit
board here.
Attention must be paid to the fact that different feeder elements must be used for analog or
digital operation.
The feeder element for analog use (Art. No.: 61191) is equipped with a suppressor capacitator and has a
GB
connection cable with a hollow connector
The feeder element for digital use (Art. No.: 61190) is without a suppressor capacitator and has a connec-
tion cable with a dual-terminal connector.
Fig. 3
Fig. 4
... and attach it with the screw associated with it.
Place the feeder element in the holder...
Openings have been made in the area of the faces for laying the connection cable in the sub-base of the
track bed. The connection cable can also be guided to the outside at positions on the acclivity provided for
this apart from this. The acclivity is laid thinner at these points and can be levelled to the corresponding
size with a file (fig. 5).
Fig. 5
Levelling for laying cables
Levelling for laying cables
11
Publicité
