Bosch Rexroth CSS/B Mode D'emploi page 58

26 Bosch Rexroth AG
If only dismantling the motor, begin with
step 4.
1 Loosen the two hexagonal screws
M6 (WS8) on the fl ange.
2 Remove the gear motor from the
hexagonal shaft.
3 Unscrew the cover plate from the
faulty gear and fi t onto the new gear.
4 Loosen the four hexagonal screws
M5 (WS8) with locking washers on
the gear fl ange.
5 Remove the faulty gear from the
motor.
Assemble in reverse order.
6 Remove the yellow protective cap
"X" from the motor shaft on the new
motor.
7 Grease the motor shaft and
hexagonal gear shaft before
assembly. The hub of the new gear
has already been greased at the
factory.
9.2.1 Replacing the motor or gear,
exterior motor mounting
The CD MTparts 3 842 529 770 contains video tutorials about changing motors,
gears, and toothed belts, which can be found under "Maintenance Video for TS
2plus".
(2x)
SW8
M = 5 Nm
D
TS 2pv
CSS/BM
gleitmo 585K
1
5
3 842 540 837 (2010.02)
2
4
(4x)
SW8
M = 5 Nm
D
7
3
Antiseize
"X" 6
Fig. 8