Use; Switching On And Off; Stapling / Nailing; Troubleshooting - Parkside PET 25 B1 Instructions D'utilisation Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before use / Use / Maintenance and cleaning / Service / Warranty
Impact force controller
Increase impact force:
T urn the impact force controller
Decrease impact force:
T urn the impact force controller

Use

Q

Switching on and off

Q
S et the ON / OFF switch
switch on the device.
S et the ON / OFF switch
switch off the device.

Stapling / nailing

Q
S witch the device on by setting the ON / OFF
switch
to position "I".
3
P ress the device with its front plate
point on the surface of the material where you
wish to staple or nail.
P ress the trigger
1
NOTE: The integral safety lock in the front
plate prevents unintentional firing.

Troubleshooting

Q
Cause:
A staple or nail is blocking the device.
Solution:
O pen the magazine slider
the pretension. Release the screws on the front
plate
using the hex key (Fig. D).
7
R emove the staple or nail.

Maintenance and cleaning

Q
DANGER OF INJURY! Pull
the mains plug out of the mains socket before you
clean or maintain the device.
34 GB
2
anticlockwise.
2
clockwise.
2
to position "I" to
3
to position "0" to
3
at the
7
.
. This releases
4
The electric nailer / stapler is designed to be main-
tenance-free.
A lways keep the device clean, dry and free
from oil or grease.
C lean the device immediately after you have
finished using it.
D o not allow any liquids to enter the device.
U se a cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.

Service

Q
repaired at the service centre or by
qualified specialist personnel using
original manufacturer parts only. This
will ensure that your device remains safe to use.
needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.

Warranty

Q
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
Have your device
If the plug or lead

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ian 273474

Table des Matières