HME wireless IQ Mode D'emploi

wireless
BELT-PAC AND HEADSET OPERATION:
Power on/off
Headset volume up
Headset volume down
or Talk to customers
Talk to crew
Mode
One-Touch Hands Free
With power off
Mode
Press
Setup
Release buttons
press and release A1 or A2
button to talk to customer
Customer arrives
Alert tone in headset
Single
Touch-Release
Lane
Speak/Listen to customer
Operation
Touch-Release
Communication ends
In Tandem operations, Order Taker #1 uses the A1 button for
customers at order point #1 and Order Taker #2 uses the A2
Customer arrives
Alert tone in headset
1 beep = connected lane
Dual
2 beeps = other lane
Lane
Touch-Release
Operation
Touch-Release
Touch-Release opposite button
to change lanes
Speak/Listen to customer
Touch-Release
Communication ends
COMMUNICATOR STATUS:
CHANGE BATTERY:
If you hear "Battery low" or "Change battery" in your headset;
Slide battery-release latch in direction of arrow
Place battery in battery-charger port for recharging
Install fully charged battery in Belt-Pac or headset
For more detailed operating instructions, go to www.hme.com/userManuals.cfm
For HELP call HME Technical Support at 1-800-848-4468 or Fax (858) 552-0172
+ +
In this mode,
or
or or
button for customers at order point #2
for Lane 1
for Lane 2
/ or
With power off ― Press
IQ
Drive-Thru Communication System
Push To Talk
With power off
Press + +
Release buttons
In this mode,
press and hold A1 or A2 button
to talk to customer
Customer arrives
Alert tone in headset
Press & hold or
Speak to customer
Release to listen
Customer arrives
Alert tone in headset
1 beep = connected lane
2 beeps = other lane
Press & hold for Lane 1
Press & hold for Lane 2
Speak to customer
Release / to listen
Auto Hands Free
With power off
Press + (
(A1 for Single Lane or Lane 1)
(A2 for Lane 2)
Release buttons
In this mode,
talk to customer
without pressing buttons
Customer arrives
Alert tone in headset
Speak/Listen to customer
Touch-Release
Communication ends
In Tandem operations,
only Order Taker #1 can operate
in the Auto Hands Free mode
Customer arrives
Alert tone in headset
1 beep = connected lane
2 beeps = other lane
Speak/Listen to customer
Touch-Release
Communication ends
+ +
or ) +
or or
or or
HME# 400G580F
Rev A 4/25/06