Copying Scenes, Programs And Records; Sound-Control; Midi-Operation - EuroLite OPERATOR Mode D'emploi

Delete step
Press and hold the Program-button. Select the desired chaser via the Chase-buttons. Press the Display-
button in order to switch the display to step. Press the respective Bank-buttons in order to select the scene
which is to be deleted. Press the Del-button.
Press and hold the Program-button in order to save the edited chaser.
6.3.5 Delete a chaser
Press and hold the Program-button. Select the desired chaser via the Chase-buttons. Press and hold the
Del-button and press the Chase-button.
6.3.6 Delete all chasers
Caution: When you select this function, all programmed chaser will irrevocably be lost. The individual
scenes and programs are still maintained.
Press and hold the Bank Down-button and the Del-button while disconnecting the device from the mains.
Connect the device to the mains again.

6.4 Copying scenes, programs and records

With the Copy-function, you can make programming of programs and chasers easier by copying already
existent scenes into a program.
Copy a scene
Press and hold the Program-button and select the desired program via the Bank-buttons. Press the
respective Scene-button. Press the Add-button and select the desired bank where you want to copy the
scene to. Press the desired Scene-button.
Delete a scene
Press and hold the Program-button and select the desired program via the Bank-buttons. Press the
respective Scene-button. Press and hold the Del-button and press the desired Scene-button. The DMX-
value of this scene is set to 0.
Copy a program
Press and hold the Program-button and select the desired program via the Bank-buttons. Press the Add-
button and select the desired bank where you wish to copy the program to. Press the Bank Copy-button.
Delete a program
Press and hold the Program-button and select the desired program via the Bank-buttons. Press and hold the
Del-button and press the Bank Copy-button.
Delete all scenes
Caution: When you select this function, all programmed scenes will be irrevocably lost!
Press and hold the Program-button and the Bank Down-button while disconnecting the device from the
mains. Connect the device to the mains again.

6.5 Sound-control

You can activate the sound-control by pressing the Music-button (LED flashes). Please note that programs
and records are only active in this mode when the controller receives a music-signal. If there is no music
present, the program or chaser stops.

6.6 MIDI-operation

Press the MIDI-button and the third and fourth digit in the display start flashing. Select the respective MIDI-
channel via the Bank-buttons. Press the MIDI-button again in order to terminate the adjustment of the MIDI-
channels.
20/41 70064520_V_2_0.DOC