PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION
GAS REQUIREMENTS
•
Use propane, butane or their mixtures gas only.
•
The pressure regulator and hose assembly to be used must conform to local standard codes.
•
The installation must conform to local codes, or in the absence of local codes, with the standard for the storage and han-
dling of liquid petroleum gases.
•
A dented, rusted or damaged tank may be hazardous and should be checked by your tank supplier. Never use a tank with a
damaged valve connection.
•
The tank must be arranged to provide for vapor withdrawal from the operating cylinder.
•
Never connect an unregulated tank to the heater.
LEAKAGE TEST
•
Gas connections on the heater are leak tested at the factory prior to shipment. A complete gas tightness check must be
performed at the installation site due to possible mishandling in shipment or excessive pressure being applied to the heat-
er.
•
Make a soap solution of one part liquid detergent and one part water. The soap solution can be applied with a spray bottle,
brush or rag. Soap bubbles will appear in case of a leak.
•
The heater must be checked with a full cylinder.
•
Make sure the safety control valve is in the OFF position.
•
Turn the gas supply ON.
•
In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply on and re- check.
•
Never leak test while smoking.
WARNING
Do not attempt any changes to the device in any way to apply. Incorrect installation, improper use,
CAUTION
EN
6