Sunred GH12 Serie Mode D'emploi page 16

ASSEMBLY
Step 7
Assemble the flame screen to the
upper support. Secure the flame
screen tot the upper support using 6
pcs screw 3/16".
WARNING
Remove protective cover before
assembling.
NOTE
Note: If necessary for proper alignment
of reflector sections, loosen each bolt
prior to further assembly and retighten
after sections are aligned.
Step 8
Slide two reflector panels together.
Insert one screw M6 X 10. Slide one
washer Φ 6 over threaded end of
screw M6 X 10 and screw on cap nut
loosely.
EN
15