Wahl 1871 Li Traduction Du Mode D'emploi D'origine page 10

Masquer les pouces Voir aussi pour 1871 Li:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
ENGLISH
f The blade set using the hygienic spray.
de
f Oil the blade set with the blade set oil (Fig. 9).
f For a good and long-lasting cutting performance, it
en
is important to oil the blade set frequently.
f If the cutting performance deteriorates after long
fr
use despite regular cleaning and oiling, the blade
set should be replaced.
it
Automatic Sensor System
To give you advance notice of an urgent need for maintenance
es
care, your hair cutting appliance has been equipped with an
automatic sensor system.
pt
·
The sensor system automatically recognises when
the blade set needs oiling or cleaning. After the
nl
appliance is switched off, an acoustic signal will
sound and the battery power indicator will flash
da
for 2 minutes.
·
The acoustic signal and the flashing of the battery
sv
power indicator can be cancelled (turned off) by
briefly switching the appliance on and off.
·
Before using the appliance again, it is urgently
no
recommended to clean the appliance and oil the
blade set, see chapter Cleaning and care.
fi
·
Failure to observe these instructions may result
in damage to and early failure of the appliance,
which will void all guarantee claims.
tr
Changing the blade set
pl
1. Slide the blade set off the housing in the direction of the
arrow (Fig. 7ⓐ). Remove the blade set.
cs
2. Replace the blade set by hooking it into the housing and
pressing it down until it clicks into position (Fig. 7ⓑ).
sk
Problem elimination
hr
Blade set is cutting badly or pulling hair out.
Cause: Blade set is dirty or worn out.
hu
f Clean and oil the blade set (Fig. 8/9); if this does not
resolve the problem, replace the blade set (Fig. 7).
sl
Battery operating time is too short.
ro
Carefully clean and oil the blade set (Fig. 8/9). A blade set that
is very dirty and has not been oiled can halve the available
battery operating time! If the blade set is clean and oiled and
bg
the battery operating time is still far too short, it is likely that the
batteries are nearing the end of their life.
ru
Battery operating time generally decreases at a
steady rate when used on a day-to-day basis. The
uk
batteries used here are specially designed for profes-
sional and everyday use, but are also affected by
et
this..
Skin injury
lv
Cause: Too much pressure on the skin.
f Reduce pressure when cutting close to skin.
lt
Cause: Damaged blade set.
el
f Check whether the blade edges were damaged during use
and replace the blade set if necessary.
ar
10
Battery power indicator light does not light up.
Cause: Appliance has not been correctly placed on the charg-
ing stand.
f Ensure that the hand-held appliance has been correctly
placed on the charging stand.
Cause: Defective power supply.
f Ensure that the power supply unit is plugged into the mains
socket.
f Check the mains cable for possible damage.
f Check the power supply.
Entire battery power indicator is flashing
f Check whether the blade set is blocked and the blade is
able to move. Switch the appliance on and off. If the entire
display is flashing, please contact your specialist retailer or
a WAHL service centre.
Appliance is not working.
Cause: Defective power supply.
f Make sure that contact between the mains and the socket is
faultless. Check the mains cable for possible damage.
In the event that this information does not help you resolve your
problem, please contact our service centre. Never attempt to
repair the appliance yourself!
Disposal
Handle with care! Environmental damage in the
event of incorrect disposal.
f Discharge batteries prior to disposal!
f Correct disposal will ensure environmental protec-
tion and prevent any potentially harmful impact on
people and the environment.
Adhere to the relevant legal requirements when disposing of
the appliance.
Information on the disposal of electrical and electronic
appliances in the European Community:
Within the European Community, national regulations
are specified for the disposal of electrical appliances,
based on EU Waste Electrical and Electronic Equip-
ment Directive 2012/19/EC (WEEE). In accordance
with this, the appliance can no longer be disposed of
with the local or domestic waste.
The appliance will be accepted free of charge by local
collection points or recycling centres.
The packaging for this product is made from recy-
clable materials. Dispose of this in an environmentally
friendly manner by recycling it.

Publicité

Table des Matières
loading

Table des Matières