Hoover SteamVac FH50015 Mode D'emploi page 7

2-5
continuing use.
Check clean solution tank also; it may need
to be refilled.
The tanks
Clean solution tank
(upper tank)
The clean solution tank holds the cleaning
solution that is to be dispersed onto the
surface to be cleaned.
How to fill
Disconnect carpet cleaner from
electrical outlet.
Place carpet cleaner handle in the upright,
locked position.
To remove tank, press down on handle (F)
and pull forward.
2-8
wax with your SteamVac™ carpet clean-
er.
2-6
E
Carry tank to a sink.
Rotate tank cap counterclockwise and lift
up to remove cap.
Turn cap (A) upside down to serve as a
measuring cup.
Using cap, measure detergent following the
chart below.
For carpet, carpeted stairs and uphol-
stery:
Fill cap to fill line (5 ounces) with HOOVER
Carpet/Upholstery Detergent.
For bare floors:
NOTE: Use only HOOVER detergents.
They are specially formulated for use with
5 OUNCES/
your SteamVac™ carpet cleaner.
150 ml
*Available at additional cost if not included with
your model.
A
For heavy traffic areas:
Pre-treat with HOOVER Spot and Stain
Spray Cleaner.
If you do not have access to the Spot
and Stain Spray Cleaner, double the
amount of HOOVER Carpet/Upholstery
Detergent (use 2 capfuls or 10 ounces
per 1 gallon tank).
CAUTION: Detergents contain
Anionic and Nonionic Surfactants.
Avoid contact with eyes and skin. In
case of contact with eyes, flush with
cold water for 15 minutes. In case of
contact with skin, wash with water. If
Irritation persists, call a physician.
Pour detergent into tank. Fill tank to
fill line (B) (1 gallon) with hot tap
water.
To assure proper performance, use only
HOOVER cleaning detergent.
2-7
F
Fill cap to fill line (5 ounces) with HOOVER
Hard Floor Cleaning Solution*.
Do not use Hard Floor Cleaning Solution on car-
pet or upholstery. Do not use any type of
If rubber ring (C) on cap has become dis-
lodged, reposition it with uneven side
against ledge (D) as shown.
Replace cap. Rotate cap clockwise until
it locks in place. Cap must be locked
in place for proper performance and
to prevent leaking.
Position bottom of tank into unit and press
Continued ➔
7