Beko MGC 20100 W Mode D'emploi page 6

Important safety and environmental
1
instructions
All appliance surfaces may be very
•
hot when the appliance is in use.
Door and outer glass may be very
•
hot when the appliance is in use
do not use the microwave oven.
1.1.1 Electrical safety
If the supply cord is damaged, The
•
supply cord must be replaced by
the manufacturer or its service
agent or a similarly qualified per-
son in order to avoid a hazard.
Beko Microwave Ovens com-
•
ply with the applicable safety
standards; therefore, in case of
any damage on the appliance or
power cable, it should be repaired
or replaced by the dealer, service
center or a specialist and author-
ized service alike to avoid any dan-
ger. Faulty or unqualified repair
work may be dangerous and cause
risk to the user.
Make sure that your mains power
•
supply complies with the informa-
tion supplied on the rating plate of
the appliance.
The only way to disconnect the
appliance from the power supply
is to remove the power plug from
the power outlet.
6 / EN
Use the appliance with a grounded
•
outlet only.
Never use the appliance if the
•
power cable or the appliance itself
is damaged.
Do not use this appliance with an
•
extension cord.
Never touch the appliance or its
•
plug with damp or wet hands.
Place the appliance in a way so
•
that the plug is always accessible.
Prevent damage to the power
•
cable by not squeezing, bending,
or rubbing it on sharp edges. Keep
the power cable away from hot
surfaces and naked flame.
Make sure that there is no danger
•
that the power cable could be ac-
cidentally pulled or that someone
could trip over it when the appli-
ance is in use.
Unplug the appliance before
•
cleaning and when the appliance
is not in use.
Do not pull the power cable of the
•
appliance to disconnect it from its
power supply and never wrap its
power cable around the appliance.
Do not immerse the appliance,
•
power cable, or power plug in
water or any other liquids. Do not
hold it under running water.
Microwave Oven / User Manual