To Deflate And Store The Alpha Active 3 Mattress - GETINGE Arjohuntleigh Alpha Active 3 Manuel D'utilisation

To Disconnect the
Tubeset
Transport Mode
Transport mode is non-therapeutic offering support only for up to
12 hours. It is recommended that when in transport mode the
patient is frequently monitored.

To Deflate and Store the Alpha Active 3 Mattress

To deflate the mattress:
To store the mattress
To disconnect the tube-set at any time, depress the
buttons on the top and bottom of the tubeset connector
pull the tube-set connector away from the pump.
To deflate the mattress Refer to Page 11 "To Deflate
and Store the Alpha Active 3 Mattress".
To transport a patient using the
overlay, disconnect the tube-set from the pump and
place the attached cap over the end of the tubeset to put
the mattress into transport mode. This will automatically
switch the mattress into transport mode.
The patient will remain supported by the mattress for up
to 12 hours.
To resume normal operation, simply reconnect the tube-
set and run the pump.
Caution
1. Disconnect the tube-set from the pump.
2. Activate the CPR control to deflate the mattress.
Following deflation:
1. Bring the tubeset over the mattress to lie parallel to
the foot end of the mattress.
2. Roll the mattress from the foot end toward the CPR
connector at the head end of the mattress.
11
mattress
Alpha Active 3