Barista CM1025AD-GS Mode D'emploi page 23

Problem
The fuse in the fuse
box is triggered.
Water runs out of the
device. / The coff ee
jug (8) overfl ows.
The device does not
brew any coff ee.
The coff ee runs very
slowly into the coff ee
jug (8).
A large amount of
steam is produced in
the brewing process.
23
Possible cause
Too many devices connected
to the same circuit.
There is too much water in
the water tank (7).
There is too much coff ee
powder in the permanent
fi lter (13).
The permanent fi lter (13) or
fi lter insert (12) is not inserted
correctly.
There is no water in the water
tank (7).
The permanent fi lter (13) or
the coff ee bean compart-
ment (2) is not fi lled with cof-
fee powder or coff ee beans.
The Start / Stopp (start /
stop) button (20) has not
been pressed.
The overheating protection
has been activated.
The coff ee powder used is
too fi nely ground.
The drip stop is blocked.
The device is furred up.
The device is furred up.
Fix
Reduce the number of devic-
es in the circuit.
Do not overfi ll the water
tank!
Do not overfi ll the permanent
fi lter.
Correct the fi t.
Pour water into the water
tank.
Add the quantity of coff ee
beans or coff ee powder you
want.
Start the device.
The device has overheating
protection which prevents
the device from being
switched on again directly
after a brewing process for
safety reasons. Wait for a
few minutes until the device
has cooled down before
you start another brewing
process.
Use coff ee powder with a
coarser grinding fi neness.
Clean the coff ee outlet with
drip stop.
Descale the device.
Descale the device.
EN