HJC C91 Mode D'emploi page 6

Shield Removal
1. Open the shield to its maximum open position. Do not force.
2. Move the handle-locker to the open position.
3. The shield will be automatically released out of the base ratchet mechanism.
Shield Installation
1. Ensure that the handle-locker is in the open position.
2. Align and insert the top of the shield guide into the plate-gear guide.
3. With the guides properly aligned, press the lower section of the shield into the Plate-Gear
mechanism. The locking tab should pop into position, locking the shield into place.
Always check to make sure helmet pads are installed before using the helmet.
A helmet with missing or improperly installed pads may increase your risk of serious
injury or death in an accident.
Cheek Pad Removal
There are 3 snaps holding the cheek pad in place.
1. Gently pry the check pad away from the interior, releasing the snaps.
2. Grasp the cheek pad near its center and gently pull it free from the chin strap.
9
Cheek Pad Installation
1. Feed the chin strap through the opening in the cheek pad.
2. Align and fully slide the cheek pad plastic plate between shell and EPS.
3. Clip the cheek pad's 3 small male snaps to the 3 female snaps fixed on the shell interior.
Chin Curtain Removal
1. Carefully pull the chin curtain fabric away from the two front chin bar snaps and it will be released.
Chin Curtain Installation
1. Align the chin curtain snaps with the two female snaps on the chin bar. Push into place.
10