Publicité
Les langues disponibles
Les langues disponibles
WELL™ 2.0 QRG
Wireless
Operation
Initial Setup
Configuration
Product Pairing
Storage Notes
The WELL™ 2.0 product can operate in W-DMX™ mode up to 300 m
(900 ft.) from the W-DMX™ transmitter. The W-DMX™ receiver in the
WELL™ 2.0 product must be paired with the W-DMX™ transmitter for
wireless operation.
1.
Turn the W-DMX™ transmitter on.
2.
Connect the W-DMX™ transmitter to a DMX controller.
3.
Place the WELL™ 2.0 product within 300 m from the W-DMX™
transmitter.
4.
Disconnect any DMX cable from the WELL™ 2.0 product.
5.
Turn the WELL™ 2.0 product on.
1.
From the WELL™ 2.0's control panel, go to RUN > DMX.
2.
Select the start address, as with any other DMX compatible product.
3.
Go to WDMX > ACTI.
4.
Select ON.
Product Already Paired
·
If the WELL™ 2.0 product has already been paired with the
W-DMX™ transmitter, the red LED on the On/Off switch will flash
slowly.
·
In this case, the WELL™ 2.0 product is ready to work in wireless
mode.
Pairing the WELL™ 2.0 Product and a new W-DMX™ Transmitter
1.
From the WELL™ 2.0's control panel, go to WDMX > REST.
2.
Select YES (the red LED on the On/Off switch will illuminate solid).
3.
From the W-DMX™ transmitter, press <RESET> (the SIGNAL
indicator will flash).
4.
Once the transmitter has found the WELL™ 2.0 product, the SIGNAL
indicator on the W-DMX™ transmitter will illuminate solid.
5.
The red LED on the On/Off switch will flash slowly indicating the
presence of DMX signal.
Always store the product in an upright position (≤ 10º tilt).
·
·
Recharge the battery to full capacity before storing the product.
·
Store charged product(s) in a dry environment, away from direct
sunlight.
·
Turn the battery switch off if storing the product for more than 7 days.
4
EN
Publicité
